ASROCK H61TM-ITX Instrukcja Właściciela

1H61TM-ITXUser ManualVersion 1.0Published November 2012Copyright©2012 ASRock INC. All rights reserved.

101.3 Unique FeaturesASRock Extreme Tuning Utility (AXTU) ASRock Extreme Tuning Utility (AXTU) is an all-in-one tool to fine tune different s

11 USB storage and launch this tool by pressing <F6> or <F2> during POST to enter the BIOS setup menu to ac-cess ASRock Instant Flash. Pl

12ASRock XFast RAM ASRock XFast RAM is a new function that is included in ASRock Extreme Tuning Utility (AXTU). It fully utilizes the memory sp

13ASRock Fast Boot With ASRock’s exclusive Fast Boot technology, it takes less than 1.5 seconds to logon to Windows 8 from a cold boot. No more

141.4 Motherboard Layout

151 Intel H61 Chipset2 SATA2 Connector (SATA_1)3 USB 2.0 Header (USB8)4 Chassis Fan Connector (CHA_FAN1)5 Consumer Infrared Module Header (CIR1)6 SATA

161.5 I/O Panel** There are two LEDs on the LAN port. Please refer to the table below for the LAN port LED indications.ACT/LINKLEDSPEEDLEDLAN Port

17Chapter 2: InstallationThis is a Thin Mini-ITX form factor motherboard. Before you install the motherboard, study the conguration of your cha

182.1 Installing the CPUIn order to provide the LGA 1155 CPU sockets more protection and make the installation process easier, ASRock has added a new

19Pin1alignment keyalignment keyPin11155-Pin CPUFor proper installation, please ensure to match the two orientation key notches of the CPU with the

2Copyright Notice:No part of this manual may be reproduced, transcribed, transmitted, or translated in any language, in any form or by any means, exce

202.2 Installing the CPU Fan and HeatsinkThis motherboard is equipped with 1155-Pin socket that supports Intel 1155-Pin CPUs. Please adopt the type

212.3 Installing Memory Modules (DIMM)This motherboard provides two 204-pin DDR3 (Double Data Rate 3) SO-DIMM slots.Step 1. Align a DIMM on the slot

222.4 Expansion Slots (PCI Express Slots)There is 1 PCI Express slot and 1 mini PCI Express slot on this mother-board.Mini-PCIE Slot: MINI_PCIE1 is u

232.5 Installing Serial SATA / SATA2 Hard DisksSTEP 1: Connect the SATA power cable to the hard disk.STEP 2: Connect one end of the SATA data cable

24SATA Power Connector(SATA_POW1)(see p.14, No. 10)2.6 Power ConnectorsPlease connect a SATA power cable.

252.7 Installing the System PanelConnect the power switch, reset switch and system status indicator on the chassis to this header according to the pi

262.8 Onboard Headers and ConnectorsOnboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Plac-

27Front Panel Audio Header(9-pin HD_AUDIO1)(see p.14, No. 26)Analog Surround Audio Header(17-pin HD_AUDIO2)(see p.14, No. 27)This is an interface for

28Power LED Header(3-pin PLED1)(see p.14, No. 11)3W Audio AMP Output Wafer Header(4-pin SPEAKER1)(see p.14, No. 28)Please connect the chassis speaker

29HDMI_SPDIF Header(2-pin HDMI_SPDIF1)(see p.14, No. 25)This header provides SPDIF audio output to HDMI VGA cards, allowing the system to connect HDMI

3Contents1. Introduction ... 5 1.1 Package Contents ...

30LPC Debug Header(13-pin LPC1)(see p.14, No. 30)PIN Signal Name PIN Signal Name14 +3V 13 No pin12 +3V 11 +3V10 GND 9 GND8 LAD3 7 LAD26 LAD1 5 LAD04 L

31Clear CMOS Jumper(CLRCMOS1)(see p.14, No. 31)CLRCMOS1 allows you to clear the data in CMOS. To clear and reset the system parameters to default setu

322.10 Operating System SetupThis motherboard supports various Microsoft® Windows® operating sys-tems: 8 / 8 64-bit / 7 / 7 64-bit / VistaTM / VistaT

332.10.2 Installing Windows® 8 64-bit / 7 64-bit / VistaTM 64-bit on a HDD Larger than 2 terabytes (2TB) without RAIDThis motherboard ado

342.11 Installing DriversThe Support CD that comes with the motherboard contains necessary driv-ers and useful utilities that enhance the motherboard

352.12 Dual MonitorDual MonitorThis motherboard supports dual monitor. With the internal VGA output sup-port (HDMI, DVI and LVDS), you can enjoy dual

362.13 Hot Plug for Hard Disk DrivesThis motherboard supports Hot Plug for SATA2 in AHCI mode.What is Hot Plug?If the HDDs are NOT set for RAID, it i

37Points for attention, before you process Hot Plug:1. Without the SATA 15-pin power connector interface, Hot Plug cannot be processed.2. Even tho

38 How to Hot Plug an HDD:Please follow the instructions below to process Hot Plug. Improper procedures will cause the HDD damage and data loss.Connec

39 How to Hot Unplug an HDD:Please follow the instructions below to process Hot Unplug. Improper procedures will cause the HDD damage and data loss.Un

43. UEFI SETUP UTILITY ... 40 3.1 Introduction ...

40Chapter 3: UEFI SETUP UTILITY3.1 IntroductionThis section explains how to use the UEFI SETUP UTILITY to congure your system. The UEFI chip on th

413.1.2 Navigation KeysUse < > key or < > key to choose among the selections on the menu bar, and use < > key or <

423.2 Main ScreenWhen you enter the UEFI SETUP UTILITY, the Main screen will appear and display the system overview.Active Page on EntryThis allows y

433.3 OC Tweaker ScreenIn the OC Tweaker screen, you can set up overclocking features.CPU CongurationCPU RatioUse this to change the ratio value of

44Use this to congure short duration power limit in watts. The default value is [Auto].Primary Plane Current LimitUse this to congure the maxim

45DRAM tRCDUse this to change RAS# to CAS# Delay (tRCD) Auto/Manual set-tings. The default is [Auto].DRAM tRPUse this to change Row Precharge Tim

46[Auto].ODT WR (CHB)Use this to change ODT (CHB) Auto/Manual settings. The default is [Auto].ODT NOM (CHA)Use this to change ODT (CHA) Auto/Manual se

473.4 Advanced ScreenIn this section, you may set the congurations for the following items: CPU Configuration, Nouth Bridge Configuration, South Bri

483.4.1 CPU CongurationIntel Hyper Threading TechnologyTo enable this feature, a computer system with an Intel processor that supports Hyper-Threadi

49CPU Thermal ThrottlingUse this to enable CPU internal thermal control mechanism to keep the CPU from overheated. The default value is [Enabled].No-E

51. IntroductionThank you for purchasing ASRock H61TM-ITX motherboard, a reliable motherboard produced under ASRock’s consistently stringent quality

503.4.2 North Bridge CongurationPrimary Graphics AdapterThis allows you to select [Onboard] or [PCI Express] as the primary graphics adapter. The de

51Volume ControlUse this to ne tune the desired volume.

523.4.3 South Bridge CongurationOnboard HD AudioSelect [Auto], [Enabled] or [Disabled] for the onboard HD Audio. If you select [Auto], the onboard H

53when the power recovers. If [Power On] is selected, the AC/power resumes and the system starts to boot up when the power recov-ers.Good Night LEDUse

543.4.4 Storage CongurationSATA Controller(s)Use this to enable or disable the SATA Controllers.SATA Mode SelectionUse this to select the SATA mode

553.4.5 Intel(R) Rapid Start TechnologyIntel(R) Rapid Start TechnologyUse this to enable or disable Intel(R) Rapid Start Technology. Intel(R

563.4.6 Intel(R) Smart Connect TechnologyIntel(R) Smart Connect TechnologyUse this to enable or disable Intel(R) Smart Connect Technology. In

573.4.7 Super IO CongurationSerial PortUse this to enable or disable the onboard serial port.Serial Port AddressUse this to set the address for the

583.4.8 ACPI CongurationSuspend to RAMUse this to select whether to auto-detect or disable Suspend-to-RAM. Select [Auto] to enable if the OS support

59system.CSMPlease disable CSM when Fast Boot is enabled. The default value is [Enabled].

61.2 SpecicationsPlatformThin Mini-ITX Form Factor: 6.7-in x 6.7-in, 17.0 cm x 17.0 cm (Compatible with Mini-ITX)Solid Capacitors for CPU powerCPUSu

603.4.9 USB CongurationUSB 2.0 ControllerUse this to enable or disable the USB 2.0 controller.USB 3.0 ControllerUse this to enable or disable the US

613.4.10 Trusted ComputingSecurity Device SupportUse this to enable or disable BIOS support for security devices.

623.5 ToolOMG (Online Management Guard)Administrators are able to establish an internet curfew or restrict internet access at specied times via OMG.

63OS. Please note that you must be running on a DHCP congured computer in order to enable this function.Network CongurationUse this to congure in

643.6 Hardware Health Event Monitoring ScreenThis section allows you to monitor the status of the hardware on your sys-tem, including the parameters

653.7 Boot ScreenThis section displays the available devices on your system for you to con-gure the boot settings and the boot priority.Fast BootFas

66after boot-up.Full Screen LogoUse this item to enable or disable OEM Logo. The default value is [Enabled].AddOn ROM DisplayUse this option to adjust

673.8 Security ScreenIn this section you may set or change the supervisor/user password for the system. You may also clear the user password.Secure B

683.9 Exit ScreenSave Changes and ExitWhen you select this option the following message, “Save congu-ration changes and exit setup?” will pop out. S

7Audio7.1 CH HD Audio with Content Protection (Realtek ALC892 Audio Codec)Premium Blu-ray audio supportLANPCIE x1 Gigabit LAN 10/100/1000 Mb/sRTL8111E

8CAUTION!1. Due to limitation, the actual memory size may be less than 4GB for the reservation for system usage under Windows® 32-bit operating syste

9 WARNING Please realize that there is a certain risk involved with over-clocking, including adjusting the setting in the BIOS, applying Untied Over